CD-700

Specifications:

TRANSMITTER

• Input power - 110 VAC
• Output frequency - 1.2 Khz
• Maximum output voltage - less than 40 VAC
• Maximum output current - 550mA
• Controls - phase select, test mode, & off-on
• Dimensions - 2.75"W x 4.75"H x 2.25"D
• Weight - 1 lb.

DETECTOR

• Input Power - 9 VDC
• Display - sequential LED
• Controls - sensitivity, short switch and open switch
• Filters - Bandpass, 1-2 Khz
• 60hz rejection - greater than 40db
• Dimensions - 2.75"W x 4.75"H x 2.25"D
• Weight - 1 lb.

Features:

• Saves replacement cable. Pinpoints problem in minutes without replacing or further damaging the cable.
• Find opens and shorts in AC & DC trailing cable.
• Fault indicator light on transmitter identifies faulted wire eliminating a need for a volt-ohm meter.
• Transmitter output protected, harmless to operator.
• Color-coded alligator clips enable quick connection to cable plug when fault occurs.
• LED indicators on detector for better visibility underground.
• A mounting bracket is located on the side of the transmitter for detector storage. The detector can be locked to the transmitter.
• 18 gauge stainless steel enclosure.
• Finds opens above 350 ohms, shorts below 1000 ohms, without ground monitor filter installed at load end.
• Finds opens above 1500 ohms, shorts below 350 ohms, with ground monitor filter installed at load end.